2023 Sprinter 170 EXT

Daniel

Staff Member
New design for our clients 170 EXT which focuses on rear open area with Tetra Van indoor shower.

Capture1.jpg
Capture2.jpg
Capture3.jpg
Capture4.jpg
Capture5.jpg
Capture6.jpg
Capture7.jpg
Capture8.jpg
Capture9.jpg
Capture10.jpg
 
The new style if Tetravan shower is a bit different so we adjust our 3D model. We then started framing out the new dimensions we will need for the shower. Using the laser scan of the van we can model to within mm of acuracy.
sprinter-van-houston (3 of 3).jpg
sprinter-van-houston (2 of 3).jpg
sprinter-van-houston (1 of 3).jpg
 
Our welder starts working on the rear driver's side module that will house the shower fold-down.

sprinter-van-houston (2 of 20).jpg
sprinter-van-houston (3 of 20).jpg
sprinter-van-houston (4 of 20).jpg
sprinter-van-houston (5 of 20).jpg
 
Next we create the top side that will act as a murphy bed.

sprinter-van-houston (9 of 20).jpg
sprinter-van-houston (6 of 20).jpg
sprinter-van-houston (13 of 20).jpg
sprinter-van-houston (17 of 20).jpg


The factory Mercedes wiring harness is depinned/removed all the through the van and relocated behind the wall. This will allow us to build the wall without any worry about wiring getting in the way.

sprinter-van-houston (20 of 20).jpg
 
Last edited:
Our client would like vertical storage closet so we add a 28" wide closet next to the bench seating area.

sprinter-van-houston (2 of 6).jpg


sprinter-van-houston (1 of 6).jpg
sprinter-van-houston (3 of 6).jpg
sprinter-van-houston (4 of 6).jpg
sprinter-van-houston (5 of 6).jpg
sprinter-van-houston (6 of 6).jpg
 
Next step is layout the new bed bench and module location. We want to be able to swivel around the drivers side seat.
van-conversion-houston-15.jpg
van-conversion-houston-11.jpg
van-conversion-houston-12.jpg
van-conversion-houston-13.jpg
van-conversion-houston-14.jpg
 
Back
Top